Curious about what types of heating systems Warmup’s 7iE thermostat is compatible with? Find your answer here in this post!
Preparing for your project
Wondering about the maximum load of the Warmup 7iE thermostat? Find the information you are looking for here in this post.
Are you looking for the dimensions of Warmup’s 7iE Smart Thermostat? Find a detailed diagram with dimensions in this post.
Our Ultralight Insulation Boards significantly reduce the time it takes to heat the floor, allowing the space to warm up faster and saving you money by reducing the time heating cables are in use. Ultralight is not required in any application, but Warmup recommends using Ultralight on all subfloors* and strongly recommends it for subfloors that […]
Overcurrent, Ground Fault Circuit Interrupter (GFCI), and Ground Fault Equipment Protection (GFEP) are all types of electrical protection equipment mechanisms, but they serve different purposes and operate in distinct ways. Attached is an explanation of each and their differences.
No, unfortunately you cannot use one 240V circuit to supply power to ALL controls / heating mats. Since the thermostats have GFCI protection built-in, those areas / heating mats will need to be supplied with Non-GFCI Protected Circuits.
A snow-melting system is most efficient when the slab is preheated. As a rule of thumb, a snow-melting system should start preheating for 1 -2 hours before the arrival of snow/ice.
If you are planning for a large project, Warmup recommends limiting the number of relays controlled by a single thermostats to 5.
Sheet vinyl is a great solution over an underfloor heating system as long as the vinyl does not have insulating properties greater than R1.5.
Learn everything you need to know about installing underfloor radiant heating in a shower floor.